Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Failure
Power indicator does not light
Power indicator is lit but the motor
does not start.
Shredder runs continuously
The motor works, but the paper is not
captured
*When the device is used longer than noted on the control panel "HOT" indicator will light.
**When the bin is not pushed against the stop "BIN" indicator will light.
*** When the engine is overheated "HOT" indicator will light.
If none of the above applies and the equipment still does not run, please contact the appropriate
customer service centre.
14
Reason
Power cord is not connected to the
mains.
Power switch is not in "AUTO"
position.
Waste waste bin is overfilled*
Waste bin is not pushed in up to the
end**
The motor is overheated***
Start sensor of receiving chute may be
clogged with paper.
The paper was not inserted properly.
Troubleshooting
Solution
Connect power cord to the mains.
Turn power switch to "AUTO" position.
Empty the bin
Push in waste bin up to the end
Switch off power and continue
operation not earlier than in 30 min.
Clear the paper blockage at the auto
start sensor (center) location .
Insert the paper against the stop
Werbung
Inhaltsverzeichnis
