Installation; Permitted Solvents - Nexa DRESTER 1000-IS Betriebsanleitung

**********ENGLISH**********
PURPOSE OF THE MACHINE
This machine is designed to clean air-driven spray-guns that have been used for spraying with the NEXA Autocolor
Aquabase waterborne paint system. The arrangement of the machine and the way to use it as described below, has been
approved by NEXA Autocolor in Slough, London. CHECK CAREFULLY WITH THE APPROPRIATE AUTHORITY TO
ENSURE THAT THE FILTERED WATER OBTAINED AFTER THE COAGULATION PROCESS MAY BE EMPTIED
INTO THE REGULAR DRAIN-WATER SYSTEM. YOU MAY NEED INFORMATION FROM NEXA AUTOCOLOR WHEN
DOING SO.
ASSEMBLY
The machine is delivered in a box containing one complete unit. All you need to assemble the machine is a 10 and 12 mm
spanner, as well as a 2,5 mm allen screw spanner. To assemble it, simply follow the enclosed sequence of pictures (9019).
PLACING THE UNIT
The DRESTER 1000 is equipment Category 3 (ref. ATEX-directive 94/9 EC) and may therefore be placed in locations
classified as Zone 2 (ref. ATEX-directive 1999(92 EC).

INSTALLATION

Connect compressed air of 5-12 bar (80-180 psi) to the air inlet of the machine. The air supply to the machine must pass
through a water trap and a filter, in order to prevent contamination entering the air system of the machine. Failure to fit a
suitable water trap and filter can result in damage to the machine which will invalidate the warranty of the machine.
Place a container of fresh water beside the machine, and put the suction hose into the container (see picture 1).
Fit an air coupling onto the airline for spray guns on the right side of the machine (No.10 picture 1).
Connect the ground cable to to prevent the build up of static electricity in the machine.
This manual is part of the unit and must be kept accessible at all times.

PERMITTED SOLVENTS

Water is recommended by NEXA Autocolor for use with this machine. Solvent-based thinner/gun wash must NOT under
any circumstances be used in this machine.
2