Troubleshooting - Kruger TX20015PRO Bedienungsanleitung

When bringing back into use, ensure that there are no
cracks or cuts in the water supply hoses.
Oil and chemical products must be disposed of accor-
ding to current legislation.
SCRAPPING
If you decide that the cleaner is no longer to be used,
render it inoperative by removing the electric power
cable. Ensure that all parts of the cleaner that could be
a source of danger are made harmless, especially for
children who might use the old cleaner for play. As the
cleaner is considered special waste, dismantle it and
divide the material according to type, then dispose of
them as required by the legislation in force.
Do not use parts dismantled for scrap as
spare parts.
TROUBLE-SHOOTING
Before carrying out any operations, disconnect the cleaner from the power (via the omnipolar switch or by
unplugging the plug from the socket) and water supply.
FAULTS
When the switch is turned the
cleaner does not start.
No jet delivered.
The pump turns but does not
reach the rated pressure.
When the lance is turned on
the pressure falls and rises.
Insufficient detergent suction. Tap turned off.
Presence of water in oil.
Water leaks from head.
CAUSES
Faulty electric connection.
Thermal protection has tripped.
The omnipolar switch has tripped.
Faulty water circuit connection.
Clogged water filter.
Mains tap turned off.
Detergent tap turned on.
Water intake filter blocked.
Faulty water circuit connection.
Pressure regulation valve is set at
minimum.
Lance nozzle is worn.
Detergent intake device on the lance is
turned on.
Dirty or worn valves.
The nozzle is clogged or deformed.
Insufficient supply.
No detergent in the tank.
Control on the lance not switched on.
Oil seal rings worn.
Gaskets worn.
18
TREATMENT OF WASTE
ELECTRONIC EQUIPMENT
Dispose of the product in accordance with
current regulations concerning differentia-
ted waste disposal in dedicated waste di-
sposal areas.
Do not treat as simple urban waste.
For any information please contact the manufactu-
rer at the address specifi ed in the user manual.
The product complies with the requirements of the
new directives introduced for the environmental sa-
feguard and must be disposed of appropriately at
the end of its life cycle.
IMPORTANT:
For maintenance and/or repairs, use only original
spare parts which offer the greatest characteristics of
quality and reliability. Failure to use original spare
parts frees the manufacturer from all responsibility.
REMEDIES
Check the mains voltage.
Reset (if it trips again, apply to the
technical service centre).
Reset (if it trips again, apply to the
technical service centre).
Check it.
Clean it.
Turn it on.
Turn it off.
Clean it.
Check it.
Regulate it.
Apply to our technical service centre.
Turn it off.
Apply to our technical service centre.
Clean or consult our technical service
centre.
Check it.
Turn it on.
Fill the detergent tank.
Set the control on the lance.
Apply to our technical service centre.
Apply to our technical service centre..
FROM ELECTRIC/