Maintenance - Kruger TX20015PRO Bedienungsanleitung

U S I N G T H E M U L T I R E G A D J U S T A B L E
NOZZLE.(FIG. 14)
Pressure must be selected with the gun
switched off.
Low pressure washing and detergent suc-
tion.
Move the nozzle forward.
Washing at high pressure with a concentra-
ted jet of water
Turn the nozzle in an anti-clockwise direction.
Washing at high pressure with a fan-shaped
jet of water
Turn the nozzle in a clockwise direction.
USE OF THE DOUBLE LANCE (fig. 15).
The double lance allows the operator to select a low
or high pressure jet. The pressure is selected with the
gun in pos. 1. High pressure: pos. 2. Low pressure
and detergent intake: pos. 3.
REGULATING PRESSURE.
This chapter concerns only those models
provided with the "pressure regulating"
device. The pressure regulator, fig. 16, allows the
operator to adjust the working pressure. When knob
C is turned in an anti-clockwise direction (B) (minimum),
the working pressure is reduced.
ADVICE ON USING DETERGENTS
This cleaner has been designed for use with the
detergents supplied or recommended by the manu-
facturer.
The use of other detergents or chemicals may influence
the safety of the cleaner.
1) For environmental compatibility, we recommend a
reasonable use of detergents, according to the instruc-
tions on the pack.
2) From the range of recommended products, choose
the one most suited to the washing job to be done and
dilute it with water according to the instructions on the
pack or in the catalogue of the detergents most suited
for the type of hot or cold water cleaner.
3) Ask your dealer for the detergents catalogue.
OPERATING PHASES FOR CORRECT CLEA-
NING WITH DETERGENTS.
1) Prepare the solution of detergent at the concentration
most suitable for the type of dirt and the surface that
is to be washed.
2) Start the cleaner, turn on the detergent tap (if
present), switch on the detergent suction control on
the lance (fig. 14) and spray the dirty surface with the
diluted product, working from bottom to top.
Let it react for a few minutes.
3) Rinse the whole surface well from top to bottom at
high pressure.
4) After using with detergent, flush out the intake circuit;
place the detergent suction hose (fig. 12) in a tank of
clean water and let the pump run for 1 minute with the
dosing tap turned fully on and the lance in detergent
delivery condition.
ADDITION OF DETERGENT
The detergents must not be al-
lowed to dry on the object to be
cleaned.
Thedetergent adjustment knob (Fig. 21) is used to
increase/decrease detergent flow.
Fill the detergent tank (Fig. 7) with detergent, di-lute
as recommended.
When high pressure is selected, the deter-
gent CANNOT be delivered! (Fig. 22)

MAINTENANCE

ONLY THE OPERATIONS AUTHORIZED IN THIS
INSTRUCTIONS MANUAL MAY BE CARRIED OUT
BY THE USER.
ALL OTHER OPERATIONS ARE FORBIDDEN.
For maintenance of the high pressure pump, the
electrical parts and all parts with a safety function, you
must apply to our technical service centre.
Disconnect the machine from the power and water
supply before carrying out any maintenance jobs.
Close the water supply tap (see chapters on connecting
to the electricity and water mains). Once maintenance
has been completed, ensure that the closing panels
have been correctly reassembled and anchored with
the screws provided before reconnecting the cleaner
to the mains.
Failure to do so may cause a risk of
electric shock.
RECAUTIONS AGAINST FROST.
The cleaner must not be exposed to frost.
If the cleaner is left in premises where it is exposed to
frost, when work is over or for storage, antifreeze must
be used to prevent serious damage to the hydraulic
circuit.
16