Exiting Functions; Adjust Display Intensity; Tones On/Off; Zone And Mode Selection - Motorola MCS 2000 I Bedienungsanleitung

input is required, use the selector (D) to select the
desired function. Press the select button (13).
A list of potential menu functions is found in the back
of this user guide (page 19).

Exiting Functions

If your radio is programmed with a HOME button (3),
press it to exit any function/menu.
If no HOME button is programmed, press the function
button once to exit the function. If the function is
accessed via the menus, press the menu button (9)
twice to exit.

Adjust Display Intensity

Select the menu INTNSITY as described above. Press
the select button (13). The display intensity may then
be adjusted to one of four levels: high, medium, low or
very low, using the selector (D).

Tones On/off

The tones heard every time a key is pressed may be
turned off or on through the menus.
Select the menu TONES as described above. Press
the select button (13). The display then shows the
present state e.g.
MCS 2000 Model I
English
TONE ON
Use the mode selector (D) to toggle between "TONE
OFF" and "TONE ON". Press the select button (13)
when the desired state is in the display.

Zone and Mode Selection

A mode is a channel or talkgroup and all its related
features. A zone is a grouping of modes that can be
selected by pressing the zone button (1). Use the
mode selector (D) to display the desired zone e.g.
SECURITY
The zone name flashes until you press the select but-
ton (13) to choose it. Then use the mode selector (D)
until the desired talkgroup/channel is displayed, e.g.
GROUP 1
68P81083C05-C
page 5