Preparation For Operation - GRAPHITE 56H100 Betriebsanleitung

for arranging the power wire. The stand allows supporting the material being machined even in case of
long components. This is enabled by the arms with supports which are protruded from the support beam.
The stand can be easily transported while in the folded position (without the mitre saw installed). The
transportation handle facilitates carrying the stand.
The applicability of the mitre saw universal stand allows easy arrangement of the workplace, both inside
and outside of a workshop. The extendable supports for the material will facilitate construction works done
with the use of wooden and wood-based elements, i.e. roof truss, garden bower, garden furniture, home
furniture etc.
Do not use the mitre saw universal stand for other purposes than intended.
DESCRIPTION OF GRAPHIC PAGES
The below numbering refers to the elements of the device which are presented on the graphic pages of
the present manual.
1. Support beam
2. Leg
3. Leg locking pin
4. Extension arm beam
5. Extension arm
6. Extension arm locating wheel
7. Support and limit stop
8. Power wire brackets
9. Transport handle
10. Positioning catch
11. Mitre saw installation bracket
12. Bracket release lever
13. Bracket security pin
14. Support locking bolt and limit stop
* Some differences may appear between the drawing and the product.
DESCRIPTION OF USED GRAPHICS
NOTE
WARNING
INSTALLATION / SETUP
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Installation brackets
2. Supports with limit stop
3. Installation bolts
UNFOLDING AND FOLDING OF THE STAND
Unfolding of the mitre saw universal stand (Fig. A).
●
Set up the stand upside down as in the transport position.
●
Press the locking pin with your foot and hold it (
●
Unfold the leg of the stand (
●
The unfolded position will be locked automatically.
●
Follow the same procedure in case of the remaining legs of the stand.
●
Put the stand on its legs by turning it over.
- 2 units
- 2 units
- 1 set

PREPARATION FOR OPERATION

3).
2).
11