Operating Elements And Connections; Front Panel - Omnitronic RRM-502 Bedienungsanleitung

4 4 4 4 Operating Elements and Connections

Front panel

No. Element
1 Input source selector
2 CUE switches with LED
3
LEVEL controls
4 HI/LOW tone controls
5
MIC LEVEL control
6 BOOTH LEVEL control
7 MASTER LEVEL control
8 BALANCE control
9 CUE SPLIT/CUE MIX
selector
10 PGM/CUE control
11 CUE LEVEL control
12 Headphones input
2
1
3
Function
Selects the rear-panel sources to be used with the respective input
channel 1 to 5.
Assigns the respective channel to the headphone bus for pre-fader-
listening (PFL) by means of the headphones output (12). The LED
indicates the pressed position.
ALPS potentiometers (Blue Velvet RK27) to set the volume for
channel 1 to 5.
To adjust the high (HI) and low (LOW) frequencies for the DJ
microphone ranging from -~ to +6 dB.
Level control for the DJ microphone.
Level control for the BOOTH output (15).
Level control for the master signal. The master signal is sent via the
MASTER jacks.
For adjusting the balance left/right for the master signal.
Defines the monitoring mode for the headphones. CUE SPLIT: the
prefader level (mono) is on one side and the output signal (mono)
is on the other side of the headphones. CUE MIX: a mixed signal of
prefader level and master signal is on both sides of the
headphones.
Controls the monitoring signal for the headphones. Left stop
position PGM: the music program currently playing is monitored
ahead of the master and booth output controls. Right stop position
CUE: the prefader level of the input channel of which the button
CUE (2) is pressed is monitored.
Level control for the monitoring output PHONES (12).
Front 6.3 mm jack for connecting stereo headphones. Turn the
level control (11) down before plugging in any headphones, as
sudden high-volume impact may damage your ears.
15 • EN
4 6 7
5 9 10
8
11 12