Megasat HD 6000 DS Bedienungsanleitung Seite 40

4. Main menu
To make various settings according to your satellite system, select the desired satellite and then press
the u key to enter the right-hand setting window.
LNB
Here you can set the LNB type according to your satellite system. The default setting (Universal 9750-
10600) is correct in most cases. If you select Unicable as LNB type, please follow the following settings:
Unicable (EN 50494 and EN 50607):
In the menu item LNB Type, you can make the settings for single-cable systems (Unicable, Unicable 2).
The set-top box is programmable for different Unicable systems. Depending on the system, up to 32
set-top box can be connected.
Unicable A / B (EN 50494)
This setting is suitable for Unicable systems with up to 4 users. IF programs allow you to select
up to 8 different programs, each IF program being assigned a frequency. Select the desired IF
program (1-4). Then select the main frequency and confirm with OK. Now enter the frequency
according to your Unicable system.
Use the Unicable A / B option to control up to 2 satellites.
SCD A / B (EN 50607)
This setting is suitable for Unicable 2 systems with up to 32 users. IF programs allow you to select
up to 32 programs, each IF program being assigned a frequency. Select the desired IF program
(1-32). Then select the main frequency and confirm with OK. Now enter the frequency according
to your Unicable system.
Use the SCD A / B / C / D / E / F / G / H option to control up to 8 satellites.
Note:
Basically, one uses the lowest frequency for the longest cable path to the set-top box. Note that
each frequency may only be present once in your system. The frequencies depend on your
single-cable system and can not be allocated as desired. IF program and IF frequency must
compulsorily match your Unicable system.
14
ENGLISH