Specifications - Konig SAS-DUMMYCAM80 Anleitung

Introduction:
CCTV dummy camera in outdoor housing with (fake) IR LED. Professional design for the
impression of security. With built-in flashing LED. Adjustable mounting bracket included.
Placing the batteries:
Open the battery compartment at the back of the camera with a screwdriver. Place 2x AA
1.5 V batteries in the battery compartment, ensuring that they conform to the correct polarity
marking inside the battery compartment. After placing the batteries, close the battery
compartment.
Adjusting the angle of the camera/bracket:
The camera/bracket can be adjusted in two ways.
1) Pull back the bracket while holding the camera in one hand. Turn the angle of the
camera/bracket.
2) Loosen the screw in the bracket and adjust the angle. Do not forget to tighten the screw
after the angle is adjusted.

Specifications:

• Depth:
• Height:
• Diameter camera:
• Battery:
• Housing:
• IP protection:
27 cm
14.5 cm
9.2 cm
2x 1.5 V AA (not included)
plastic
IP65
2
ENGLISH