Electrical Connection - Beem Air Joy Cool Bedienungsanleitung

Air Joy Cool
ATTENTION
► Do not pull the connecting cable
to remove the plug from the mains
socket.
► Do not put objects into the openings
or ventilation grilles.
► Keep the appliance free from dust,
fluff, hair and above all, anything that
could restrict the air flow.
► Do not use sharp objects or abra-
sive/polishing cleaning agents to
clean the surfaces.
► Do not move the appliance by grip-
ping the air ring.
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the installation location must
satisfy the following requirements:
■ Place the appliance on a firm, dry, flat
and waterproof surface.
■ Do not install the appliance in a hot,
wet or very humid environment.
■ The mains socket must be easily ac-
cessible and allow fast disconnection
in the event of an emergency.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the feet of the appliance. If
necessary, place a mat under the feet
of the appliance.
14

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on
the electrical connection must be be ob-
served:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. This
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains cable is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the mains cable to prevent risk
of tripping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle
En