remis REMIflair IV Montageanleitung Seite 8

B. Information about installation
We recommend the blackout system to be installed by an authorised service
centre! In case of defective installation we shall neither assume liability nor
US/GB
Step 1: (Check scope of delivery)
B1
B2
Step 2: (Installation of the blackout system)
B3
2
1
B4
B5
8/32
issue warranty.
B1:
REMIflair IV:
Pre-installed coffer
Guiding profi les right/left
B2:
Accessories:
2 Cassette holder
4 Countersunk screw Ø3,5x16mm
4 Rounded-head screw Ø3,5x16mm
B3:
Push the guiding profi les (1) into the frame
corner (2) of the cassette (3) until they click. Be careful
not to clamp the cords.
3
B4+B5:
Pull the two cords through the guiding profiles and lock
them onto the support feet, according to picture B5.
Please make sure the cords are parallel and not twisted.
The cord tension is already adjusted, so the cord clamps
must not be loosened. An eventual tightening has to be
made as shown in Appendix D.