Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation:
1.
Remove the battery compartment cover. Insert three Alkaline batteries into the battery compartment observing the
+ and - polarity signs; then replace the battery compartment cover.
2.
Set up the Crossliner on the floor or on the tripod (optional). If you use a tripod, hold the centring nut on the device
in one hand and turn the screw on the tripod into the centring nut on the device. Tighten the screw.
3.
Switch on the device (Pos. 9): this switches on the power supply and the levelling system is unlocked at the same
time to allow for automatic self-levelling. (Switch off the device: the power supply is switched off and the levelling
device is automatically locked at the same time).
4.
Adjust the three levelling screws so that the bubble is in the black circle.
as an aid for levelling the Crossline. Levelling of the laser diodes is handled internally (items 3 and 5) and is inde-
pendent of the sight glass.
5.
If the laser beam flashes while the device is switched on, the angle of the device is too large; readjust the three
screws of the tripod accordingly.
6.
Point the plumbline beam with the target on the floor and align with the target. Then move the fine adjustment
mechanism and the top part of the device to adjust it roughly so that you can align more precisely with the targets.
The fine adjustment mechanism is only used for fine adjustment of the targeted mark and not for a complete 360
degree rotation.
7.
If the device angle exceeds the limit for some reason during operation, the laser beam will automatically start to
flash. In this case use the three levelling screws to adjust the setting until the laser beam stops flashing.
Care and maintenance:
1.
Never attempt to open the Crossliner. Only qualified STORCH service partners are allowed to repair the device.
2.
To guarantee precision, protect the line laser against dropping, knocks and impacts.
3.
When storing the device for an extended period of time, remove the batteries from the battery compartment.
4.
Clean the device with a soft cloth and a mild detergent.
5.
Never use aggressive chemicals, petroleum ether or other agressive cleaning agents, and do not keep the device in
a dusty environment.
6.
Clean the lenses with a spectacles cleaning cloth.
Warranty conditions:
A warranty period of 12 months from the date of purchase/date of invoice applies to our tools for commercial custo-
mers. If we have granted an extended warranty period, this said period will be noted separately in the operating manu-
al for the equipment in question.
Claims
If you wish to claim under our warranty or guarantee, please return the entire tool and your invoice to our works, pos-
tage paid, or send it to one of our authorised service centres.
Your rights under our warranty or guarantee
Repair claims can only be accepted for material defects or manufacturing errors, and only assuming intended use of the
appliance. Wear parts e.g. batteries are not covered by warranty. Fitting third party parts, improper use and storage,
and obvious failure to observe the operating instructions will void your warranty.
Repairs
All repairs must be conducted on our premises or by an authorised STORCH service centre.
Please note: the sight glass is only used
21
Werbung
Inhaltsverzeichnis
