Installation - REV Ritter QH-863A Anleitung

GB
To reset the bell push, hold down the button (3) on the wireless bell for approx. 5 seconds. When
the LED indicator light comes on, all of the saved connection information will have been erased.
Now remove the batteries from the wireless bell(s) and the bell push(es) and reinsert them after 30
seconds. Once the batteries are back inside their respective appliances, the bell push and wireless
bell can be paired with each other for 30 seconds. You can set up the ring tone as described in the
"Choosing a ring tone" section.
If the product is not in use/not needed for a long period of time, remove the batteries from the
wireless bell and bell push.

Installation

The wireless bell is intended to be attached to a wall with screws. Choose a suitable indoor location
for installing the device, e.g. near the door. To install on a wall, drill a hole in the wall and insert a wall
plug. Then put a screw into the wall plug and hang the wireless bell on it.
You can attach the bell push using either the double-sided adhesive tape or with screws.
Select a protected position outdoors to install it, e.g. under a roof.
To secure the bell push with screws, remove the back cover and drill through both of the
indentations. Then drill two holes into the wall and insert the wall plugs. Now screw the back cover to
the wall.
Lastly, fasten the front cover to the back cover.
The bell push can be personalised with a nameplate. Write on a small piece of paper
(approx. 18 x 24mm), lift the transparent covering on the front and slide it into place.
Then return the transparent covering to its original position.
Cleaning
• Switch the product off by remove the batteries.
• Use only a dry or slightly damp, lint-free cloth to clean the product.
Use a mild detergent if necessary. Do not use acidic or solvent-based cleaning products.
WEEE-reference of disposal
In accordance with European defaults used electrical and electronics devices may no
more be given to the unsorted waste. The symbol of the waste bin on wheels refers to the
necessity of separate collection. Please help with environmental protection and see to it
that this device is given to the for this purpose designated systems of waste sorting if you
do not use it any longer. DIRECTIVE 2012/19/EU of the EUROPEAN PARLIAMENT AND OF
the COUNCIL of 4 July 2012 on waste electrical and electronic equipment (WEEE).
Battery disposal
Batteries and accumulators are not to be disposed of in the normal house waste bin. Every
user is legally obliged, to hand over all batteries and accumulators, irrespective of whether
or not they contain harmful substances to a communal collection point in the local town
area or to a trade dealer so that they can be disposed of in an orderly environmentally
friendly manner. Batteries and accumulators should only be handed over when they are completely
discharged!
CE Declaration of Conformity
Hereby, REV Ritter GmbH declares that the radio equipment type QH-863A is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address: www.rev.de
11