Addressing; Dmx-Protocol - EuroLite N-150 Bedienungsanleitung

Addressing

Each device occupies 4 channels. To ensure that the control signals are properly directed to each device,
the device requires adressing. This is to be done for every single device by changing the DMX address as
set out in this table.
As soon as you will connect the data cable with the DMX-socket, the display shows "DMX Add". Adjust the
desired DMX-address by means of the Up/Down keys.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other device on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Setting the DMX-
starting address:
Projector number
& channels
Device 1 - channels 1-4
Device 2 - channels 5-8
Device 3 - channels 9-12
Device 4 - channels 13-16
Device 5 - channels 17-20

DMX-protocol

Control channel 1 - Control modes
Data:
232-255
128-231
14-127
0-13
1 2
DIP-switch no.
DMX-starting
1 2
address
On
Off Off
On
Off
On
Off
On
Off
On
Off
Modes:
Maximum volume
Timer
Volume control
Off (stop smoking)
22/47
3 4 5 6 7
4 8 16 32 64 128 256
8 9
51701970_V_1_3.DOC