Technical Data; Installation - Electrolux SC24312 Benutzerinformation

8 electrolux
2. Press on the rear hook and at the same
time slide the lamp cover in the direction
of the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into its
original position.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the lamp
comes on.

TECHNICAL DATA

Dimension
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of
the appliance:
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
3. If necessary, replace the defective door
Height
Width
Depth
Climate
class
SN
N
ST
T
stallation".
gaskets. Contact the Service Center.
1400 mm
600 mm
630 mm
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C