favero FC50H20 Installations- Und Gebrauchshandbuch Seite 16

E NG LISH
9.2. Opening the power supply module
1. Disconnect the scoreboard's power supply.
2. Remove the screws of the module's front panel.
3. Remove the front panel.
Dangerous voltages are present inside the module!
Fig. 4 Opening of the power module.
9.3. Removing of the transparent front panel
1. Disconnect the scoreboard's power supply.
2. Remove the two screws from the transparent front panel.
3. Remove the scoreboard's transparent panel as follows
• centrally, slide the transparent panel upwards, then extract it slightly from the base and take
it out of its seat from below;
• laterally, slide the transparent panel horizontally towards one side, then extract it slightly
from the opposite side and take it out of its seat.
Fig. 5 Removing of the transparent front panel.
9.4. Replacing a LED display board
1. Remove the front panel of the module where the board to be replaced is mounted as indicated in
chapter 9.3.
14
/ 94 00304-M02-03 - ML-FC serie scoreboards - User Manual Rev03 - 160826 -
FAV E RO E L EC T RO NIC S