Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Ponndorf Hose Pumps are self-priming rotating positive-displacement pumps without seals or valves. The liquid comes
into contact with only the interior of the hose and not with the moving parts of the pump.
This makes them particularly suited to pumping aggressive, abrasive and high viscous mediums, as well as pumping
liquids with a high percentage of solids and shear-sensitive fluids.
The Hose Pumps are baseplate mounted with coupling and driven by the motor via a gearbox.
The Pumps are supplied with lubricant grease (silicone based) for the exterior of the hose. This lubricant eases instal-
lation of the hose and provides optimum life in operation. A non-silicone based grease is available. Contact the factory
for details.
Hoses and connectors are ordered and supplied separately. One hose and a set of two connectors are required for
each pump. For dual-head pumps, two hoses and four connectors are needed.
The wiring diagram for catalog numbers ending in AAC and HAC can be found inside the conduit box attached to the
motor. Consult the motor manufacturer for all other models.
General environment
Temperature, Operating:
Temperature storage:
Humidity (non-condensing):
Altitude:
Gear motor requirements for catalog numbers ending with AAC or HAC
Motor enclosure rating is IP55.
Power supply voltage must be within 10% of the rating on nameplate.
See motor nameplate for frame size and gear motor output speed.
Refer to the gear motor manual for detailed information on motor current, motor torque, motor speed and
gear motor maintenance.
IEC664
Category III
Pollution Degree 3
Casing material of the pump is aluminum.
Customers who purchase only the pump are responsible for assuring proper motor shaft, coupling and pump shaft
alignment.
Maximum viscosity:
PX SERIES
Maximum flow rate at
165 rpm
Maximum pressure at
165 rpm
Maximum suction lift at
165 rpm
Approximate Weight
Pump Only
Approximate Weight,
Gear motor Configuration
Approximate Weight,
Mechanical Variable Speed
Approximate Weight,
Reducer Configuration
Maximum pump speed
INTRODUCTION
DESCRIPTION OF PUMPS AND SPECIFICATIONS
32 to 104°F (0 to 40°C)
–49 to 149°F (–45 to 65°C)
10% to 90%
Less than 2000 m
35,000 mPas
PX10
l/h
150
bar
2
psi
29
m
7
ft
3.3
kg
4.0
lb
8.8
kg
33.1
lb
73.0
kg
48.1
lb
106.0
kg
39.0
lb
86.0
rpm
165.0
PX102
PX15
250
500
2
2
29
29
7
7
3.3
3.3
7.5
7.0
16.5
15.4
37.19
37.7
82.0
83.0
52.2
52.6
115.0
116.0
43.1
43.6
95.0
96.0
165.0
165.0
4
PX152
PX27
950
2200
2
2
29
29
7
7
3.3
3.3
13.0
14.0
28.7
30.9
47.6
48.1
105.0
106.0
62.6
60.8
138.0
134.0
51.3
51.7
113.0
114.0
165.0
165.0
PX272
5000
2
29
7
3.3
27.0
59.5
67.6
149.0
82.6
182.0
67.1
148.0
165.0
Werbung
Kapitel
Inhaltsverzeichnis
