Installing The Stove; Assembly Sequence - Olsberg Tolima PowerSystem II Compact Anleitung

Installing the stove

and horizontal. The stove may only be installed on an

Assembly sequence

non-combustible spark protection plate must be used.
This must extend 50 cm to the front and 30 cm to each
side beyond the edge of the combustion chamber
opening. Under the stove no spark protection plate is
required.
● If intended, install the OEC.
● If intended, install storage stones.
Comply with the information in the instruction manu-
al included with the storage stones.
● The Ø 150 mm stovepipe needs to be connected at
the top of the appliance.
● Decide where the stove is to be installed. There
must be no objects made of combustible materials
within a distance of 80 cm of the stove's radiation
area, measured from the combustion chamber's in-
spection glass, nor may any be placed within this
area subsequently.
Depending on the installation position of the stove in
or load-bearing), the following distances from walls
need to be observed in accordance with the position
of the combustion chamber door to the wall / side
panel or the back panel (see schematic diagram).
When not dealing with walls that need to be protect-
ed, you merely need to observe a minimum distance
of approx. 5 cm to allow for proper heat dissipation.
● Install the pipe lining (provided on site) in the chim-
ney. The connection height can be individually spec-
not exceed 1.5 m from the connector sleeve. For the
rear stovepipe connection heights please refer the
"Technical Data" chapter. No combustible material is
permitted within a radius of 20 cm around the stove
pipe.
● Connect the stovepipe at both connection points
with stove putty so that the stove pipe is permanent-
The floor on which the stove is installed must be even ly sealed.
● Push the stove onto its planned position and orient it
adequate load-bearing floor. The stove can be stood
on a metal floor sheet or glass sheet to protect the
The stovepipe connections must be tight. The flooring.
stovepipe must not protrude into the chimney.
If the flooring or carpet is inflammable, a stable and
Bear in mind that on partition walls in accordance
of 85°C can be reached, and with light wallpaper
or similar combustible construction materials this
can result in colour changes.
front of walls that need to be protected (flammable
ified for a top stovepipe connection, however should
so that the stovepipe fits into the pipe lining.
with test specification EN 13240 the temperature
Stove installed straight in corner
15
15
Dimensions in cm
Stove installed diagonally in corner
Dimensions in cm
15
15