Maintenance / Cleaning - Laserworld el-200 led Bedienungsanleitung

Manual / Bedienungsanleitung: EL-200 LED
The address is the sum of all activated numbers, see the following example settings (the white
rectangle represents the position of the switch)
Addr switch
1
17
The laser uses 7 DMX channels, so make sure that the next device uses an address that doesn't
overlap with this range. E.g. when using address 1, make sure the next device uses at least address
8.

Maintenance / cleaning

Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the 2 upper screws on one side panel (one front and one back), then
bend side panel outward and slide out the top. Remove any deposits of dust, especially at the fan.
Check for condensed fog fluid inside, if so, clean and rearrange the position of laser and or hazer.
Mirrors need cleaning, when a "halo" is noticeable around the beam, or an unusual high amount of
diffuse light can be seen inside the
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.
Channel Value
0 – 63
64 – 127
1
128 – 191
192 – 255
2 0 - 255
3 0 - 255
4 0 - 255
5 0 – 39
40 - 79
80 – 119
120-255
6 0 – 24
25 – 49
50 - 74
75 – 124
125 – 174
175-199
200-224
225-249
250 - 255
7
device.Clean the mirrors with window cleaner and a paper towel.
:
addr switch
65
113
Laser off
Sound mode
Automatic mode
DMX mode
Pattern
Speed
Rotation
Red
Green
Red/Green
Flashing red/green (with increasing
speed)
Normal operation
Laser on, LED flashes
Laser, LED flash alternating
Laser, LED flash synchronous
Both on
LED only
Laser only
Both off
Normal operation
Colour LED
Page / Seite 5 of / von 12
Version / Stand: 11/2009