Operation - Grundig WK 5260 Bedienungsanleitung

OPERATION _________________________________

Preparation
1
Remove all packaging and sticker materials
and dispose of them according to the applica-
ble legal regulation.
2 Before using the appliance for the first time,
clean all parts which come into contact with
water carefully. (See the "Cleaning and care"
section).
3
Completely roll out the power cord from the
rewind on the bottom of the base
I
the power cord through the slot on the base.
4
Fill the water tank with water.
5
Set the kettle on its base
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6 Pour out the hot water and rinse the kettle with
water. This will remove any remaining manu-
facturing residues from the inside of the water
tank.
7
Clean kettle well before initial use and discard
water of first two boiling cycles.
Operation
1 Push the lid release button
open the lid .
C
― The lid opens automatically.
C
2
Fill the water tank with water.
Notes
Do not place the water tank on the base
7
while filling it with water.
Never fill the water tank above the maximum
7
level indicator or below the minimum level
indicator.
3 Close the lid until it clicks into place.
C
4
Place the water tank on the base
sure that it is sitting in an upright and stable
position.
5 Insert the plug into the wall socket.
6
Press down On/Off switch
. Pass
H
. Make sure that
H
on the kettle to
D
H
H . Make
.
G
― On/Off switch
G
ing process begins.
Note
Lid should always be closed during the
C
7
boiling process; otherwise the kettle will not
switch off automatically.
7 After a few minutes, the water will start to boil.
The kettle switches off automatically and On/
Off switch moves upwards.
G
― The blue light goes off.
Note
If you want to stop the heating manually, push
7
the On/Off switch
G
8 Disconnect the plug from the wall socket.
9 Take the water tank from the base
hold it by the handle
Caution
Do not open the lid
7
splash out. Make sure that no water splashes
onto the base .
H
10
Pour the water from the spout
or glass you want to use.
Notes
If you want to continue the boiling process,
7
repeat the procedure from 1 to 10.
Let the kettle cool down between each heat-
7
ing process.
Hints and Tips
The kettle is equipped with a hard water filter
7
which filters out limestone and other resi-
B
dues when the water is being poured out.
Use softened or filtered water to prevent lime
7
build-up.
illuminates blue and boil-
upwards.
. Only
H
.
E
as hot water could
C
to the cup
A
ENGLISH 15