MAXA 3500 W Bedienungs- Und Installationsanleitung Seite 43

● SETTING THE LOUVER
In order to obtain optimal air distribution, adjust the motorised louver, making sure that the air flow is not directly pointed
at anyone. For the motorised louver, proceed as follows:
By pressing the AIR DIRECTION key several times it is possible to modify the position of the
AIR DIRECTION
deflector.
SWING By pressing the SWING key it is possible to activate continuous louver swing mode.
DANGER!
Moving the motorised louver manually when the unit is on could cause operating problems or damage the
adjustment system.
● SETTING THE FAN
By pressing the FAN SPEED key several times it is possible to adjust the fan speed between the three available
speeds, or to activate the AUTO mode. The operating mode appears on the display:
AUTO: automatic speed operation
LOW: minimum speed operation
MED: medium speed operation
HIGH: high speed operation
● SETTING THE TIMER
IMPORTANT!
In order for the timer settings to have an effect, the remote control must ALWAYS be positioned near the unit
(at a maximum distance of 8 metres) and be pointed towards the same.
The TIMER function is not repetitive and must be set whenever you wish to use it. When the Timer ON-OFF function is
selected, the unit may be switched on with a slight delay with respect to the programmed timer time. This should be
considered completely normal and does not mean that the unit is not operating correctly.
● TIMER ON and TIMER OFF: Pressing these keys makes it possible to programme the unit on and/or off time.
▲and▼: Pressing this key makes it possible to modify the switch-on or switch-off time. Whenever the key is pressed,
the time is put forward or back by 0.5h then after 10h thenit will increase with 1h in each press.
● KEYPAD LOCK
By using a sharp object to press the LOCK key it is possible to prevent use of the remote control
keypad completely, meaning that it can be protected from use by children etc. The display will
show the symbol illustrated here. To remove the keypad lock, use a sharp object to press the
LOCK key again.
● RESETTING THE REMOTE CONTROL
By using a sharp object to press the RESET key, it is possible to restore the factory settings to the remote
control.
43