Installation; Connection With The Mains; Operation; Control Panel - EuroLite UV/MG Bedienungsanleitung

INSTALLATION

Install the device on a plane surface.

Connection with the mains

Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
With the POWER-switch, you can switch the device on and off.
Note: After connection to the power supply, the unit will conduct a self-check in which the software version
appears on the displays. The counter display will show "0" when the unit is ready.

OPERATION

Control Panel

Counting-Functions
Counting
Once the bills are correctly placed in the hopper, the machine will start counting automatically. The number
of counted bill will be shown on the counter display. When beginning a new count, the display will quickly
clear (0) and the batch display will then show the number of counted bills.
International
L
N
13/16
1. Batch display
2. Counter display
3. „ + „ Key
4. „ - „Key
5. „Batch" Key
6. „Restart" Key
7. „ADD" Indicator
8. „UV" Indicator
9. „MG" Indicator
10. „BATCH" Indicator
11. „ADD" Key
12. „UV" Key
13. „MG" Key
00030423.DOC, Version 1.2