D- Using Your Deep Freezer - Ugur UDD 500 BK Bedienungsanleitung

D- USING YOUR DEEP FREEZER

Start-up
WARNING!
• Bu This operating manual applies for various device models. Hardware scopes of the models may vary.
There may be diff erences in the pictures.
• Clean inside and all accessories of your product before the first start up. (see page 21).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running your freezer. Thus, the compressor oil, which may enter into the system, will return back.
You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 22)
PICTURE 22
EN
Control Panel (Optional)
Indicators and controls on the control panel of your products are shown in Picture 23 below.
PICTURE 23
Alternative control panels
1) Thermostat setting button for setting the internal temperature of your product: When you put the thermostat setting to
"S" position or press the super button for the first time, you will run fast (super) freezing function that you can use during the
initial operation or when you want a faster freezing.
2) Fast (super) freezing lamp (yellow light) that you can use during the initial operation or when you want a faster freezing.
3) Alarm indicator that warns you with red light when internal temperature of your product reaches to critical levels.
4) Energy lamp showing your product is powered (Green light).
You will hear a slight sound from the compressor when your product is
running.
Green and red check lamps will light upon turning on your product.
Upon first operation of your product, press fast (super) freezing button
in yellow colour. Thus your freezer will make deeper freezing.
46
Alterna-
tive control
46 5
3
2
panels
1 7
8
0
9
MAX
SUPERA LARM
I
0
4
3 5
6
2
1 7
0