Storage When Not In Use; Overview; First Use - Silvercrest SWR 300 A1 Bedienungsanleitung Und Serviceinformationen

Storage when not in use

If the device will not be used for a long period of time, disconnect the wireless repeater from the
mains power supply. Ensure that the storage temperature remains between -20 °C and 60 °C. The
humidity should not exceed 90% rel. air humidity.
Please note: the temperature range and relative air humidity for storage and use are quite different;
please see the information in the "Operating environment" section.

Overview

First use

Plug the wireless repeater into a properly installed power socket. The optimal position for the
wireless repeater is exactly in the middle between your router and the wireless devices which are to
be connected to the network using the wireless repeater. Test other locations if the wireless repeater
does not work there. There are two different ways to configure the wireless repeater. If your router
supports WPS, you can use this simple function to easily install the wireless repeater. If you wish to
use a router without a WPS function, you can connect the wireless repeater to your computer and
configure it using a LAN connection.
1 Power LED
2 WLAN LED
3 WPS LED
4 LAN LED
5 WPS button
6 LAN socket
7 Reset button
SilverCrest SWR 300 A1
English - 59