De Dietrich AD251 Montageanleitung Seite 6

English
Installing the outside sensor
To mount the outside temperature sensor, proceed as follows:
1 Pair the outside temperature sensor with the boiler's radio module - Package AD252
2 Select the position for the outside temperature sensor
It is important to select a place that allows the sensor to measure the
outside conditions correctly and effectively.
Advised positions:
- on one face of the area to be heated, on the north if possible
- half way up the wall in the room to be heated
- under the influence of meteorological variations
- protected from direct sunlight
- easy to access
A: recommended position on a corner
B: Possible position
6
Each outside temperature sensor is given a unique identifying
number in the factory, which enables the boiler's radio module to
recognise it. The identifying number is transmitted to the boiler's radio
module by the pairing sequence.
Refer to the assembly instructions for the boiler's radio module.
C002449-A
H: Inhabited height controlled by the sensor
Z: Inhabited area controlled by the sensor
Positions to be avoided
- masked by a building element (balcony, roof, etc.)
- close to a disruptive heat source (sun, chimney, ventilation grid,
etc.)
AD251
8800N002-C
19/03/2009 - 300020521-001-A