Operational Elements - Magnat MULTI MONITOR 220 Wichtige Hinweise Zur Installation / Garantieurkunde

OPERATIONAL ELEMENTS

LED status indicator for the active speaker (Fig. 1)
• red: Standby mode
• red, flashing: Mute mode active, device is muted
• green: analogue input active (Phono/Line)
• orange: AUX input active (3.5 mm jack socket)
• white: digital inputs active (optical/coaxial)
• blue: Bluetooth input active, connected to the source device
• blue, flashing quickly: Bluetooth input active, device in pairing mode
• blue, flashing slowly: Bluetooth input active, no source device connected
Rear controls of the active speaker (Fig. 2)
(2) Power switch
(3) Mains connection
(4) Switch PHONO/LINE
(5) Earth terminal GND
(6) RCA IN: Analogue stereo input (RCA jack)
(7) AUX IN: Analogue stereo input (3.5 mm jack socket)
(8) SUB OUT: Output for connecting an active subwoofer
(9) DIGITAL IN OPTICAL: Optical digital input
(10) DIGITAL IN COAXIAL: Coaxial digital input
(11) Rotary/push button for volume control and source selection
(12) LEFT CHANNEL OUTPUT: Connection for the left passive speaker
ATTENTION:
The loudspeaker is equipped with an integrated amplifier and needs to be connected to a mains outlet by means of the supplied mains cable.
Operation with the system remote control (fig. 3):
(13) ON/STBY: Switches the device on when it is in the standby mode. If the Standby-LED (fig. 1 (1)) does not illuminate, actuate the power
switch (fig. 2, (2)) located on the rear. Conversely the device can be switched from power operation to the standby mode.
(14) VOLUME: Increases (+) or decreases (-) the volume.
(15) TREBLE: Increases (+) or decreases (-) the volume of high frequencies for manual adjustment of the sound pattern.
(16) BASS: Increases (+) or decreases (-) the volume of low frequencies for manual adjustment of the sound pattern.
(17) LINEAR: Resets all of the changes made to the frequency response (buttons 15 and 16) to a neutral setting.
(18) MUTE: Switches the sound on and off.
(19) SOURCE: Selects the audio input: PHONO/LINE, AUX IN, DIGITAL IN, BLUETOOTH
(20) PAIR: Switches the device to the pairing mode when in Bluetooth operation to establish a connection to a Bluetooth source device. The
blue LED status indicator (Fig. 1, (1)) flashes quickly.
11