Inno home SA101 Gebrauchsanleitung Seite 19

2. Press the Stove Alarm push-button for about 5 seconds, until
you hear a beep.
3. Release the push-button and press again straight after, hold-
ing until the Stove Alarm emits a beep.
4. Now press the push-button as many times as the level (1-16)
you wish to set it to, with short presses. Wait for the light to
go off between each press of the push-button.
5. The Stove Alarm now confirms its sensitivity level with
beeps:
Beeps (given in two lots)
2 + 2
3 + 3
4 + 4
...
15 + 15
Checking the sensitivity level
To check which sensitivity level has the Stove Alarm been set to,
carry out the procedure below.
1. Press the Stove Alarm push-button for about five seconds,
until you hear a beep.
2. Press the push-button again, until you hear a beep.
3. The Stove Alarm will now emit as many beeps as is the sen-
sitivity level it has been set to, and a signal X that gives infor-
STOVE ALARM SA101 USER MANUAL
Sensitivity level
2
3
4
...
15
11