Beninca BE.TOUCH Bedienungsanleitung Seite 14

interval are heard. The system is waiting for
the code.
- Type the code to be checked followed by
ENTER.
If the code is memorised, BE.TOUCH replies
with 1, 2 or 3 beeps:
- Rolling-code: 1 beep
- Advanced rolling code (ARC): 2 beeps
- Fixed Code: 3 beeps
MENU 9
Code repetition activation with ENTER
Through this function it is possible to enable the
button, ENTER as code "repeater", during the
20 seconds following the code introduction.
T h i s f u n c t i o n m i g h t b e u s e f u l t o
c h e c k t h e a u t o m a t i c s y s t e m s p r e s e t
with Step-by-Step cycle operation (e.g.
OPEN>STOP>CLOSE>STOP>OPEN>).
After 20 seconds, the system exits the repeti-
tion mode and a new valid code shall be typed
in again.
In the factory configuration this function is
disabled.
After typing key 9, two beeps followed by an
interval are heard. The system enters a wait
state.
- Type in 1
if the function is to be activated.
- Type in 0
if the function is to be deactivated.
Then, three beeps are heard followed by an
interval. The device activates or deactivates the
function and exits the programming mode.
TO MEMORISE THE FATHER CODES IN
THE RECEIVER
After programming the father/child codes as
required, the father codes must be stored in
the receiver memory.
Proceed according to instructions given with
the receiver.
When the receiver enter the wait state for a
code to be memorised, digit the FATEHR code
(or a Child code matched with it), press ENTER
and BE.TOUCH will send the code to be stored
in the receiver memory.
More than one receiver can be used, also
with a different decoding, and in the event of
multi-channel receivers, various codes can be
matched to various channels.
In the event of especially complex installations,
14
it is advisable to make and carefully keep a
diagram of the various receivers used, as well
as their functions and related BE.TOUCH codes
matched to it.
COMPLETE MEMORY RESET
1 Remove the batteries (if inserted) and wait
some seconds.
2 Now type in the memory reset password
"1234567890".
3 An intermittent buzz can be heard to indicate
that the memory has been erased.
The reset restored the factory presetting. All
customized codes and settings are removed.
DISPOSAL
When the product is out of order, it must be
disposed according to regulations in force on
waste disposal and recycling of the various
components (metal, plastics, electrical wires,
etc.). For this purpose, it is advisable to contact
your installer or a specialised company.