Dry Vacuum Cleaning; Wet Vacuum Cleaning - Pallmann Dust M Bedienungsanleitung

Warning
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pressure.
Set the rotary switch to the correct suc-
tion hose cross-section.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.

Dry vacuum cleaning

The device is fitted with a paper filter
–
bag with locking slide, order no. 60940
(5 pcs).
Note:You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note:The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 0.1 mg/m
Warning
The flat pleated filter must must always be
in place while vacuuming.
To vacuum fine dust, you must use an
–
additional paper filter bag or a mem-
brane filter (special accessory).
Inserting the paper filter bag
Illustration
Release and remove the suction head.
Insert the paper filter bag.
Insert and lock the suction head.
18
Horn
.
3
Install membrane filter
Danger
The membrane filter must not be used to
vacuum health-hazardous dusts.
Note: If you work without the paper filter
bag, you must use a membrane filter to pro-
tect the suction head.
Illustration
Release and remove the suction head.
Pull the membrane filter (option) over
the container edge.
Insert and lock the suction head.

Wet vacuum cleaning

Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
Remove the brush strips.
Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Close the suction connection
Illustration
Properly insert the connection socket in
the suction connection.
Push in the connection socket until it
locks into place.
Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
Remove the paper filter bag
Illustration
Release and remove the suction head.
Pull the paper filter bag out towards the
rear.
Pull the locking slide up and seal the paper
filter bag tightly when removing it.
Dispose off the used paper filter bag in a
dust-tight bag according to the statutory
provisions.
Insert and lock the suction head.
To suck wet dirt, first remove the paper
–
filter bag.
3
-
EN