Pallmann Dust M Bedienungsanleitung Seite 21

Warning
Safety equipment for preventing hazards
must be serviced and maintained regularly.
This means that the manufacturer's staff or
persons trained by the manufacturer must
check the equipment for proper functioning
at least once a year, i.e. check for leaks, fil-
ter damage, functioning of the controlling
elements, etc.
Caution
Risk of damage! Do not use detergents
containing silicone to clean.
No outside help is required for carrying
–
out basic maintenance and cleaning.
The appliance surface and the inside of
–
the container should be cleaned regu-
larly using a damp cloth.
Danger
Risk due to dust hazardous to health. Always
use disposal clothing and P2 or higher
breath-safe masks while carrying out mainte-
nance tasks (such as changing filters).
Exchanging the flat pleated filter
Open filter door.
Take out the flat folded filter.
Dispose off the used flat-folded filter in
a dust-tight bag according to the statu-
tory provisions.
Remove the dirt that has accumulated
on the pure air side.
Insert new flat-folded filter.
Close the filter door, it must lock into
place.
Exchanging the paper filter bag
Close the suction connection
Illustration
Close the suction connection, see wet
vacuuming.
Exchanging the paper filter bag
Illustration
Release and remove the suction head.
Pull the paper filter bag out towards the
rear.
Pull the locking slide up and seal the pa-
per filter bag tightly when removing it.
Dispose off the used paper filter bag in
a dust-tight bag according to the statu-
tory provisions.
Insert the new paper filter bag.
Insert and lock the suction head.
Replace membrane filter
Illustration
Release and remove the suction head.
Remove the membrane filter.
Pull the new membrane filter over the
container edge.
Insert and lock the suction head.
Cleaning the electrodes
Release and remove the suction head.
Clean the electrodes with a brush.
Insert and lock the suction head.
Troubleshooting
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Note:In case of a failure (e.g. filter break-
age) the appliance must be turned off im-
mediately. The failure must be remedied
before the appliance is put into operation
again.
Suction turbine does not run
Check cables, plugs, fuse, socket and
electrodes.
Turn on the appliance.
Suction turbine turns off
Empty the container.
Suction turbine does not start again
after the container has been
Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
Clean the electrodes as well as the
space between the electrodes with a
brush.
6
-
EN
emptied
21