Start Up; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Pallmann Dust M 060091 Bedienungsanleitung

The appliance allows 2 operating modes:
1 Industry vacuum cleaner mode (socket
not used)
2 Dedusting mode (socket used)
 Connect the suction hose and insert the
suction nozzle or connect to the dust-
generating device depending on the op-
erating mode.
WARNING
The flat pleated filter must always be in
place while vacuuming.
WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pressure.
 Set the rotary switch to the correct suc-
tion hose cross-section.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.

Dry vacuum cleaning

– The device is fitted with a paper filter
bag with locking slide, order no. 60940
(5 pcs).
Note: You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 0.1 mg/m
– To vacuum fine dust, you must use an
additional paper filter bag or a mem-
brane filter (special accessory).
18

Start up

Horn
.
3
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag.
 Insert and lock the suction head.
Install membrane filter
DANGER
The membrane filter must not be used to
vacuum health-hazardous dusts.
Note: If you work without the paper filter
bag, you must use a membrane filter to pro-
tect the suction head.
Illustration
 Release and remove the suction head.
 Pull the membrane filter (option) over
the container edge.
 Insert and lock the suction head.
Changeover from wet to dry vacuum
cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond re-
pair.
 Dry the wet filter properly before use or
replace it with a dry one.
 Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
Note: For permanent wet vacuum cleaning
it is advisable to use a PES flat pleated fil-
ter.

Wet vacuum cleaning

DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– 3
EN