Power Supply; Changing The Batteries - salvus Torino Bedienungsanleitung

3. Power supply

3.1 Changing the batteries

As soon as the batteries are almost empty (and the voltage becomes too low), the red light will flash and a
warning signal will sound five times when touching the * key. This is the warning that you need to change the
batteries.
Do not use rechargeable batteries, only high quality 1.5 AAA batteries (4 pieces). Pull the tab located under the
keyboard and place the batteries (see figure 2, page 19).
General
Signal
1x + 1x
2x + 1x
When opening the lock
Signal
3x + 3x
3x + 3x
During 5 minutes
5x + 1x
During programming
Signal
1x + 3x
2x + 2x
3x + 3x
1x + 1x
Do you have questions about your safe, the electronic lock or is there an unexpected malfunction?
Please contact your local dealer.
Explanation of sound and light signals
Explanation
Confirmation of keystroke (except ENTER)
Confirmation of keystroke ENTER
Explanation
Wrong code
Cannot be opened
3x wrong code
Batteries almost empty
Explanation
Wrong entry
Programming confirmed
Programming error
No entry for 10 seconds
Programming cancelled
Solution
Re-enter the code again after
1x + 1x
Replace batteries
Re-enter the code again after
1x + 1x
Replace batteries
Solution
Repeat procedure after
1x + 1x
Repeat procedure after
1x + 1x
Repeat procedure
21