Exotek instruments MC-380XCA Anleitung Seite 8

PIN-FREE MOISTURE METERS
MANUAL
The unit is ready for measuring after about  sec.
Hold the spring electrodes without excessive force and in an approx. 40
angel to the material.
All of the 3 measuring springs must be in good contact with the material to
be measured. See Page 3 figure 1.
Measurements may be taken in different spots of the material, or the
measuring springs could be slided across the material.
MEASURING WITH INTEGRATED BOTTOM SEN-
SOR (penetration depth up to 10 mm (½"))
After selecting the appropriate material-group the bottom of the unit must
be hold up in the air for automatic 0-correction.
The unit is ready for measuring after about  sec.
Place the unit in upright position onto the material to be measured or press
the bottom of the unit against the material.
See page 3 Figure .
The surface of the material that is to be measured have to be flat and
even. Measurements may be taken in different spots of the material.
SELECTING MEASURING MODE
: Measurement without hold function.
: Measurement with hold function
: Measured value is calculated into Relative
Humidity (only for material codes CC,
E, E3 and E4).
: MC measurements are stored and the
average value is calculated.
• " : " is showed in the left corner of the display when a value is
stored.
• The average value is flashing on the display if the green button is
pushed.
• To reset the memory, push the green button in for 5 seconds
("0.00" is flashing).
Explanation to measuring functions:
Measurement without Hold Function F1:
When the spring electrodes are moved over a surface, the MC-380XCA
continuously takes a new measurement. This function is used for fast
scanning of an area.
Measurement with Hold Function F2:
The MC-380XCA only takes one measurement when the spring electrodes
touch a surface. The value is kept on the display after the MC-380XCA
being removed from a surface. This is used for viewing the result where it
is difficult to see the display during operation. A new reading is taken when
the unit is placed on a surface again.
ENG
MC-380XCA
- 8 -
o
MENU
F1-F4