User Menu; Settings Menu; Coffee Dose Adjustment; Mills Replacement - Fiorenzato F64E V2 Bedienungsanleitung

DISPLAY
When the grinder-doser is switched on, the
display shows, on the left, the temperature, the
number of coffees made throughout the day
(Today), during the current week (Week) and
the Total. On the right, it shows the percentage
humidity, the time, the date and the grinding
mode selected in green.
26 °C 26 °C
Today: 76 Today: 76
Week: 355 Week: 355
Total: 1571 Total: 1571

USER MENU

To access the user menu, keep the C1 button
pressed until an intermittent sound starts (about
5 secs.). Three yellow buttons will light up.Use
the buttons C1 and C2 to move through the
menu and change the setting. Use the button M
to select and confirm. Exit the menu after
confirming by pressing the button M.
• Language
English, Italiano, Español, Français, Deutsch,
Português, Chinese, Russian, Korean, Malaysian,
Thai, Greek.
• Time
set time.
• Time Layout
12 or 24 hours.
• Date
set date.
• Temperature
Centigrad or Fahrenheit.
• Brightness
percentage.
• Information
Firmware version and Serial Number.
44% 44%
10:30 am 10:30 am
Wed 1 Oct 2014 Wed 1 Oct 2014
Standard Standard

SETTINGS MENU

To access the user menu, keep the C2 button
pressed until an intermittent sound starts (about
5 secs.). Three yellow buttons will light up.Use
the buttons C1 and C2 to move through the
menu and change the setting. Use the button M
to select and confirm. Exit the menu after
confirming by pressing the button M.
• Grinding Time
single and double grinding secs.

• Mills Replacement

hours.
• Mills Reset
reset mills timer.
• Factory Reset
restore factory settings.
• Statistics
show statistics.
• Manual Grinding
activate manual grinding (M) button.
• Grinding Mode
Standard, Automatic, PRE/SEL e Direct.

COFFEE DOSE ADJUSTMENT

Access the settings menu, select Grinding Time.
Then select the seconds for single grinding
option and confirm. Adjust the seconds for the
double grinding option and confirm again.
MILLS REPLACEMENT
When the grinding mills need to be replaced, a
warning appears on the display.
The state of wear can be monitored by accessing
the settings
Replacement.
IMPORTANT
After replacing
replacement timer needs to be reset. To do this,
access the settings menu, select Mills Reset and
confirm the reset.
21
menu and selecting
the grinding mills,
Mills
the