Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Introduction:
Congratulations on the purchase of this SkyTec light effect.
Please read this manual carefully prior to using the unit.
Warning
:
-
Do not look into the lamp. The short, strong flashes can cause problems on sensitive persons.
-
Unplug the unit from the mains prior to repairs, maintenance and replacement of the lamp and
let it cool down.
-
When installing the unit, make sure that nobody can touch it by accident.
-
For indoor use only.
-
During installation, nobody should stand beneath the mounting area.
-
Prior to the first use, have the unit checked by a qualified person.
-
The unit contains voltage carrying parts. DO NOT open the light effect.
-
The condensers inside the unit may still be charged although the unit is switched off.
-
Never plug or unplug the unit with wet hands.
-
If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
-
If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a
mains outlet.
-
Only connect this unit to an earthed mains outlet of 230Vac/50Hz and 10-16A.
-
Always unplug the unit during a thunderstorm or when it is not in use.
-
If the unit has not been used for a longer period of time, condensation can occur inside the
housing. Please let the unit reach room temperature prior to use.
-
When you unplug the unit from the mains always pull the plug, never the lead.
-
In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a
solid chain, a steel cable, etc. which has to be fastened separately from the mounting bracket.
-
The supplied bracket is the main fixing and must be used to solidly mount the light effect.
-
In order to avoid accidents in public premises, the local legal requirements and safety
regulations/warnings must be fulfilled.
-
Keep out of the reach of children.
-
Repairs and lamp replacement has to be carried out by a qualified technician.
-
The flash tube is operated by very high voltages up to 400V which can be lethal.
Operation:
The speed is set via the knob (1) at the rear side of the strobe. If you want to connect the unit in series
(up to 8 strobes), connect the "OUT" (3) socket of the first strobe to the "IN" (2) socket of the second,
etc. This connection has to be made via a standard ¼" mono lead. All linked strobes are flashing at the
speed of the first strobe.
GB
Werbung
Inhaltsverzeichnis
