Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

AUTOMATIC WASHING MACHINE BABYDUCK WA210
16. Empty any pockets that could contain coins, screws or other objects that could damage the wash-
ing or the machine.
17. Put small items like socks in a washing bag or a pillow case to ensure they cannot get trapped
between the tub and the drum.
18. Use a low foaming, high quality detergent. Never exceed the quantity recommended by the de-
tergent manufacturer. Using too much detergent is not good for your laundry and is hostile to the
environment.
19. Leave the door open when the washing machine is not in use to reduce wear on the seal and pre-
vent mould formation.
20. Do not put anything heavy on the machine that could damage the top.
Never let children play with the appliance.
I. INSTALLATION
1.
Removing the accessories
Open the door by pulling on the handle and remove the accessories in the drum prior to installa-
tion.
2.
Transport grip-safe pieces
All the pieces inserted to hold the drum steady during transport must be removed before using
for the first time.
Proceed as follows:
Unscrew and remove the three screws (A) fixed on the top cover, pull it forward and outwards.
Unscrew and remove the two nuts (B), remove the polystyrene then replace the cover (C).
N.B. It is advisable to keep the packaging and transport holding pieces in case the machine has
to be transported again.
A
A
3.
Positioning
Install the machine on a firm, flat surface. Make sure that nothing – carpets, cloths etc., can pre-
vent the air from circulating around the machine. Make sure that the machine is not touching a
wall or any piece of furniture as this would cause vibrations.
Level the machine by screwing the adjustable feet up or down; never place a piece of wood or any
other object underneath to set off any difference in height between one side and the other. Once
the machine is level, tighten the counter nuts on the feet.
4.
Connecting to the water supply
The appliance may only be connected to the cold tap. Screw one end of the cold water intake hose
to the threaded connection point at the back of the appliance and connect the other to the cold
water tap. The machine is designed to work with a water pressure of 0.5 to 10 bar. Check that the
connections are watertight.
B
B
3
INSTRUCTION MANUAL
C
C

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis