Sleep Timer Operation; Dimmer Control - Denver CRP-717 Bedienungsanleitung

The sleep timer allows you to play music for a preset amount of
time ranging from 90 minutes to 10 minutes. It is commonly used by
people who prefer to go to sleep to music.
1. In radio mode, Press the SNOOZE/SLEEP/DIMMER button.
The display will show 90 minutes, your clock radio will turn off in
90 minutes.
2. To change the number of minutes for the SLEEP timer, press the
SNOOZE/SLEEP/DIMMER button until you see the desired
number of minutes. The SLEEP timer decreases in increments
of 10.
3. To cancel the SLEEP timer, press and the SNOOZE/SLEEP/
DIMMER button then press again until you see OFF in the
display or press the POWER ON – OFF / ALARM OFF button.
In radio off mode, Tap the DIMMER button to set the brightness of
the LED display to high, medium or low according to your ambient
light conditions.
Remark:
1. Clock display with dimmer low" is the default setting.
2. It will consume more power if you set the clock display with
dimmer high.
Notes:
- This appliance is featured with a projection function and can be
used in either clock or radio mode. You can use this appliance to
project time on the ceiling or wall.
- Optimal projection distance ranges from ca. 90 to 270cm.
- Press PROJECTION ON/OFF button to illuminate the projection
lens. Time is projected on the ceiling or wall.
- Use angle/sharpness controller to achieve optimal projection
sharpness and angle.
- Press PROJECTION 180º FLIP button to flip the projected
image.
- To deactivate projection function, simply press PROJECTION
ON/OFF button. The projection lens goes off.
DENVER CRP-717.indd 7

SLEEP TIMER OPERATION

DIMMER CONTROL

PROJECTION FUNCTION
ENG-6
15 11 27 9:40