IMG STAGELINE MMX-8 Bedienungsanleitung Seite 10

3) Select the type of signal source
with the
SOURCE (2):
MIC = microphone
LINE = l ine input (tuner, CD,
cassette)
4) To prevent switching noise, set
both controls MASTER LEFT and
MASTER RIGHT (3) to "0". Switch
on the unit with the switch
ON / OFF (5) on the rear side. First
the LEDs ON PK above the con-
trols shortly light up at maximum
brightness and then continue to
light at lower brightness.
5) Set the input controls (1) of the
channels to which no unit has
been connected to "0". Set the
other controls to mid-position
first.
6) Adjust the output level with the
control MASTER LEFT (MONO)
so that the following unit is ad-
justed to an optimum level.
7) Adjust the mixing ratio of the
inputs with the input controls
(1) accordingly. The LED ON PK
above the control MASTER LEFT
(MONO) serves as a level indi-
cator. Correct the output level
with the control MASTER LEFT
(MONO), if required.
8) Individual channels are faded in
and out with the corresponding
input controls (1), if required.
The output signal is faded in and
out with the control MASTER
LEFT (MONO).
10
selector switches
6 Stereo Operation
In stereo operation up to 4 stereo
signal sources may be connected to
the inputs (8). The left channels are
always connected to the upper jack
and the right channels to the lower
jack.
1) Connect an amplifier or a re-
corder to the jacks (7) OUTPUT
L (left channel) and OUTPUT R
(right channel). If microphones
are connected to the mixer, the
mixer must be connected to the
microphone input of the ampli-
fier or recorder.
2) Set the selector switch MONO /
STEREO (4) to STEREO.
3) Select the type of signal source
with the
SOURCE (2):
MIC = microphone
LINE = line input (tuner, CD,
cassette)
Both selector switches SOURCE
must be set to the same position.
4) To prevent switching noise, set
both controls MASTER LEFT and
MASTER RIGHT (3) to "0". Switch
on the unit with the switch
ON / OFF (5) on the rear side. First
the LEDs ON PK above the con-
trols shortly light up at maximum
brightness and then continue to
light at lower brightness.
5) Set the input controls (1) of the
channels to which no unit has
been connected to "0". Set the
other controls to mid-position
first.
selector switches