Settings Table (Configuration) - RK MultiControl duo accu Montageanleitung

7.9 Settings table (configuration)

All the settings which you can perform on drives are described in the following table. Read in sec-
tion 7.8 for instructions on how to perform the settings.
Code
Determine the addresses of the connected drives:
0 = Off (if the drive is used individually)
113
1 = Master (address of the first drive)
2-8 = Slave (address of the other connected drives)
Set the base height of the retracted drive. The display on the hand switch then shows
133 the base height.
Parameter 213 must be switched from percentage to milimetre display prior to this.
Start initialisation: start initialisation run without having previously disconnected the mains plug of
211
the drive.
Height indication in the display:
Setting = 0 -> Height is displayed in the display in percent ("xxxP.").
213 Stroke length in mm -> Display shows the stroke moved.
If parameter 133 has a base height set, the hand switch display shows the total of the
base height and the stroke moved.
Activation of the load resistor (only with
Switching the load resistor in or out with interconnected controllers.
233
0 = off (load resistor deactivated)
1 = on (load resistor activated)
Changing the position of the decimal point of the height indication in the display:
.xxxx
xxxx.
311
xxx.x
xx.xx
Description
RKMultiControl
quadro):
7. Working life
53