Herunterladen Inhalt Inhalt Diese Seite drucken

SOLIS DECO HEATER CLASSIC Bedienungsanleitung Seite 45

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Press S H IFT once more, the temperature readout begins to blink and the sym-
bol " °C" lights up. Y ou can now set th e d esired room tem perature using the
+ or - buttons. Each press of either button on the control panel raises or lowers
the number on the display by one degree. A setting of between 15°C and 35°C
is possible (the factory set temperature is 25°C). W hen you are no longer touch-
ing the control panel, the input will blink 5 times, then it is saved and the cur-
rent room temperature lights up again.
A ttention: The operating range of the heater is between -10°C and + 4 0°C.
Should the current room temperature lie under -10°C, " LO" lights up on the dis-
play, if it is over + 4 0°C then " HI" lights up on the display. The ex act tempera-
ture is only visable on the display for a temperature range of between -10°C and
+ 4 0°C.
P ress H E A T E R to ch ang e th e pow er lev el
the high heating level is activated (2000 W att)
(N ote: the high heating level needs 20 seconds before it
begins to work)
the low heating level is activated (1200 W att)
P ress S W IN G to activ ate th e oscillation function, i.e. your heater turns from
left to right. The corresponding symbol lights up on the display. If you press
SW IN G once again, the oscillation function is switched off and the correspon -
ding lit symbol will go out.
T o turn off press th e O N /O FF-b utton on th e touch sensativ e control panel
and then press the power switch on the back of the appliance to the " 0" posi-
tion.
N otes:
1. W hen the set temperature is reached, the appliance automatically goes into
stand-by mode and the information on the display and heating element switch
off, 10 seconds later the fan also switches off. As soon as the temperature sinks
bellow 2°C the set desired temperature, the appliance automatically begins to
heat again.
2. If you lift up the appliance you can hear a sound - the cause of this is the tip-
ping protection inside the appliance and is no cause for concern.
4 5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis