Storage Locations Voice01 - Voice20; Deleting A Message; Message Sequence; Programming A Message Sequence - Monacor PA-1120DMT Bedienungsanleitung

GB

connection for remote control
6.2.3 Storage locations Voice01 – Voice20
To replay a message from one of the storage loca-
tions "Voice01" to "Voice20":
1) Press the button MENU (10). The display will
show:
Mode Set
Time
2) Press the button UP (12) or DN (11) repeatedly
Voice
until
3) Press the button ENTER (6). The display will
now show:
Choose
Play
4) Press the button ENTER. The display will now
show:
PlayBack
Voice:01
5) Use the button UP or DN to select the message
01
desired (
6) Press the button START/ STOP (14) or ENTER.
Playing
will appear on the first line of the dis-
play.
7) Press the button START/ STOP or ENTER to
stop the replay.
first line; a different message can be selected
for replay (
20
appears on the lower display line.
20
to ).
PlayBack
will appear on the
step 5).

6.3 Deleting a message

To delete a message from the storage locations
"Voice01" to "Voice20" without recording a new
message:
1) Press the button MENU (10). The display will
show:
Mode Set
Time
2) Press the button UP (12) or DN (11) repeatedly
Voice
until appears on the lower display line.
3) Press the button ENTER (6). The display will
now show:
Choose
Play
4) Use the button UP or DN to select the option
Delete
on the lower line.
5) Press the button ENTER. The display will now
show:
Delete
Voice:01
6) Use the button UP or DN to select the message
01
to be deleted ( to
ton ENTER to confirm.
The message will be deleted and the menu will be
exited. To delete further messages, start with step 1
again.
Note: Messages that are stored on the storage loca-
tions M1 – M6 can only be deleted by a new recording
( chapter 6.1.1).

6.4 Message sequence

A sequence of up to 20 stored messages may be
programmed and manually replayed in any order.

6.4.1 Programming a message sequence

1) Press the button MENU (10). The display will
show:
Mode Set
Time
2) Press the button UP (12) or DN (11) repeatedly
RECALL
until appears on the lower display
line.
3) Press the button ENTER (6). The display will
now show:
RECALL
PGM Play
4) Use the button UP or DN to select the option
PGM Edit
on the lower line.
5) Press the button ENTER. If no program has
been created yet, the display will show:
PGM Edit
P01 ---
20
) and then press the but-