How To Use The Test Lamp - Dogtra ARC Bedienungsanleitung

12. HOW TO USE THE TEST LAMP

1. To activate the receiver/collar, place the red dot on the back
of the transmitter to the red dot on the receiver/collar. Hold
the two red dots together for a moment until the LED light
on the receiver/collar comes on. The indicator light will
come on for a moment then blink once every 4 seconds,
showing that the collar is ready to use. (If the indicator light
is red, or if there is only 1 bar showing on the battery icon on
the LCD transmitter screen, the unit needs to be charged.)
2. Place the test lamp, included in the package contents, on the
contact points as shown in the diagram.
3. Turn the transmitter on by pressing the blue button on the
right side of the transmitter until the LCD screen illuminates.
The LCD screen shows the amount of battery life remaining
and the LED blinks once every 4 seconds.
4. Watch the test lamp as you push the "Nick" button on the
transmitter. It should light for just a moment. The higher the
intensity, the brighter the test lamp will be.
50
5. Watch the test lamp as you push the "Constant" button
on the transmitter. It should light for as long as the button
is pressed. However, as a safety feature, the receiver/collar
will automatically stop stimulation if the constant button is
depressed for 12 seconds or longer.
6. Turn the Rheostat Intensity Dial on the transmitter clockwise
and then counterclockwise. The test lamp should glow
brighter with higher levels of stimulation and dimmer with
lower levels. When you change the intensity dial, the number
on the LCD screen will change as well.
7. Pressing the "Pager" button on the front of the transmitter
causes the collar to vibrate for up to 12 seconds. The collar
will reactivate when you push the button again.
NOTE : The test lamp may not be visible if the intensity level
is set below level ten.
51