Operative Instructions - TECO TC500 Bedienungsanleitung

ATTENTION
Do not connect the unit to the current socket if the fairing is not assembled.
Step
Safety instructions
Rules for the
installation
4

OPERATIVE INSTRUCTIONS

Description
Don't disconnect/connect the power during operation.
This may cause a fi re due to sparks, etc.
When an abnormally (smell of burning, etc.)occurs, stop the unit and disconnect
the power or turn off the breaker.
If the unit continues to be operated in an abnormal condition, it may cause a fi re, trouble,
etc. In this case consult your dealer.
Do not connect a grounding wire to a gas pipe, water pipe, lightning rod or ground
wire of a telephone.
If a grounding is incorrect it may cause an electric shock.
No connection in the middle of power cord or extend the power cord. Multifun-
ctional socket is forbidden to be used.Do not scratch or pull the power cord.
If the supply cord is damaged, it must be replaced by qualifi ed persons in order to avoid a
hazard.
The connection to the supply must be made by 20A circuit breaker protection.
Do not insert your fi nger or stick, etc. into the air inlet/ air outlet.
Since the fan rotates at high speed, this may cause an injury.
Repair or relocation should not be done by the customer.
If this is done incorrectly, it may cause a fi re, electric shock, water leakage, etc.
ATTENTION
To grant the right functioning of the unit in safe conditions, it is absolutely
forbidden its exposition at atmospheric conditions and direct sources of heat.
The maximum ambient temperature allowed is 35°C.
ATTENTION
The place in which the unit will be installed must
have the following characteristics:
See image.
Make sure that easy access can
be gained to service panel and
plumbing connection.
Do not block access to the control
panel or electrical outlets.
Make sure the grilles are not
blocked or obstructed.
Multiple connection-install chiller 500mm apart and independently 20A circuit breaker
protection.