Conceptronic Grab’n’GO CSPBOXLCD Schnellinstallationsanleitung Seite 26

ENGLISH
6. Connect the Photobox to your PC
The Photobox can be used as a "Mass Storage Device" on your computer to read/write
the data on the device.
The Photobox also works as a "Card Reader" on your computer when connected through
USB.
A. Make sure the Photobox is turned off.
B. Connect the Mini-USB connector of the delivered USB Cable to the Mini-USB port of
the Photobox.
C. Connect the normal USB connector to a free USB Port of your computer
The Photobox will turn on and shows the USB indicator and Battery Status indicator on
the display.
Note: If the battery is not fully charged, the Photobox will charge the battery through
the USB connection. The Battery Status indicator is animated during charging.
Your PC or Notebook will automatically detect and install the Photobox on your
computer. There is no driver needed for installation.
Open "My Computer". You will see 1 new Drive for the Harddisk and 2 new removable
devices for the card slots.
26