Conceptronic Grab’n’GO CSPBOXLCD Schnellinstallationsanleitung Seite 19

ENGLISH
3. Assembly of the Photobox
Note: If you purchased the Photobox with a Harddisk included, you can skip this
chapter and continue to Chapter 4 of the manual.
To assemble a Harddisk in the Photobox, you need the following parts:
- The Photobox
- A 2,5" SATA Harddisk
- Assembly screws
- A small Philips screwdriver
A. Remove the back-cover from the Photobox.
B. Remove the rubber protection strip found in the Photobox and keep it for step E.
C. Gently place the Harddisk in the Photobox and push the Harddisk so that the SATA
connectors of the Harddisk are fitted completely in the SATA interface of the
Photobox.
(included in the package if you purchased the Photobox
without Harddisk)
(included in the package if you purchased the Photobox
without Harddisk)
C C
19