Chiller: Data Available - Hitachi HC-A32MB Installations- Und Betriebshandbuch

Operation

6.2 CHILLER: Data available

Address Name
0 EXIST
1 SYSTEM_ADDRESS
2 ONOFF_SET
3 MODE_SET
4 TEMP_SET_C
5 TEMP_SET_H
6 CENTRAL_SET
7 ONOFF_STATUS
8 MODE_STATUS
9 TEMP_C_STATUS
10 TEMP_H_STATUS
11 WATER_INLET
12 WATER_OUTLET
13 AMBIENT_TEMPERATURE Ambient temperature
14 OPER_CONDITION
15 ERROR_CODE_CH
16~21 ERROR_CODE_CYC
22~31 (Not used)
?
Notes:
– Offset Position is: 40000 + N*32 + Address as shown in table, where N is Water Chiller Address.
– Status (real value) and Set (value ordered) parameters have usually the same value but, in some cases, some of them can be
different. It is recommended to use Set parameters for normal control.
– (*) When Temperature Setting and Operation Mode are changed at the same time, order first the operation mode change and
later set the desired temperature.
Description
Exist
Chiller Address
On/Off setting order:
Mode Setting order
COOL setting temperature
HEAT setting temperature
Central Setting
On/Off Status
Mode Status
COOL Setting Temperature
Status
HEAT Setting Temperature
Status
Inlet temperature
Outlet temperature
Unit operation condition
Alarm code for general
CHILLER alarm
Alarm code for cycle alarm
(1~6)
(Not used)
Values Read/Write
0: Not exist Read
1: Exist
0~ 15 in H-LINK 1 Read
0: Stop Read/Write
1: Run
0: Cool Read/Write
1: Heat
(see note *) Read/Write
0: Local Read/Write
1: Remote
0: Off Read
1: On
0: Cool Read
1: Heat
Read
Read
Read
Read
Read
0: OFF Read
1: Thermo OFF
2: Thermo ON
3: Alarm
Read
Read
(Not used) (Not used)
PMML0191A rev.0 - 04/2009
17