Stand-By-Time; Daylight And Motion-Sensing Functions; Setting Offset; 100 H Burn-In - OSRAM DALIeco Control Handbuch

5.8 Stand-by-time

Set the duration of STANDBY or switch the STANDBY function to continuous.
Stand-by-time
• Press one of the push-buttons [Stand-by-time] (SP or LP) to
30 s 5 min ON ON ON ON ON ON
set STANDBY time for CH-1 and CH-2.
If [Stand-by-time ∞] is selected, the lighting never switches off.
Semi Semi emi Semi Semi emi
15 min 30 min
Auto A Auto A Auto Auto
60 min
OFF O O F F F O O F F F OFF
5.9 Daylight and motion-sensing functions
The daylight and motion-sensing functions can be set for:
- all connected sensors together (PROG mode
- each sensor individually (sensor select
Daylight functions
ON ON
Push-button [ON] •
Semi Semi
Auto Auto
Push-button •
OFF OFF
[Semi Auto] •
Push-button [OFF] •
Motion-sensing functions
ON ON
Push-button [ON] •
Semi Semi
Auto Auto
•
Push-button
OFF OFF
[Semi Auto]
•
Push-button [OFF] •
26
5.1)

5.12).

Fully automatic daylight control active
Automatic switch-off with too much daylight
Manual switch-on
Daylight control switched off
Motion-detection active
Automatic change to "STANDBY" or "OFF" after overrun
time has expired
Manual switch-on
Motion-detection switched off

5.10 Setting offset

Setting the OFFSET (=distance from CH-2 to CH-1) of a specific function mode.
100 h
1. Press push-button [Offset] (SP).
Burn-in PC modes Offset
ON ON
1 2
OFF OFF
Offset is set using the push-button rocker [CH-2]:
2.
CH-1 CH-2
- LP = Coarse setting
Auto
setup
- SP = Fine setting
The offset of Ch-2 can be:
Manual
setup
- min. = value of CH-1
- max. = 100 % brightness
3. Press push-button [Offset] (SP) to save the setting.

5.11 100 h Burn-in

When using fluorescent lamps, stable operation and maximum lifespan are only assured after a
burn-in phase (100 h at 100%). The automatic functions are switched off during burn-in, all lamps
in the system illuminate at 100%.
LEDs on all connected sensors light up red continuously.
1. During commissioning or before regular use of the system
100 h
Offset
Burn-in PC modes
press the push-button [100 h Burn-in ON/OFF] (SP) to start
ON 1 2 ON
OFF OFF the process.
Press push-button [100 h Burn-in ON/OFF] again (SP) to end
2.
the process prematurely.
Each function call-up restarts the 100 h time period.