Conceptronic Grab’n’GO CHD3CU Schnellstartanleitung Seite 10

ENGLISH
e. Slide back the tray in the housing, attach the back plate to the backside of the
tray and use the 2 screws to fasten the back plate.
3.2 Cable connections
a. Connect the power supply to the power outlet and to the hard disk.
b. Connect the USB cable to the CHD3CU and to a free USB port on your computer.
c. Use the power switch on the back of the CHD3CU to turn on the device. The
Conceptronic Logo on the front of the CHD3CU will light up blue.
Windows 2000 & Windows XP Automatically will recognize the hard disk. No driver
installation is required to operate the CHD3CU.
4. Safely removing the Harddiskbox
The device must be deactivated before disconnecting the device otherwise data could
be lost. You can deactivate "USB Mass Storage Device" by double clicking the icon in the
taskbar.
"Remove or eject hardware components" appears on the screen after double clicking.
Activate the appropriate USB component here and confirm with "Deactivate". A warning
appears if you do not deactivate the device before disconnecting.
10