Proper Use; Technical Description; Installing The Comfort Indicator Module - Waeco MagicTouch MT2000 Montageanleitung

MT-2000.book Seite 20 Montag, 13. Februar 2006 4:41 16

Proper use

4 Proper use
WAECO MagicTouch MT2000 (item no. MT2000) is a comfort indicator module for
retrofitting. The indicator module triggers flashing when you press the indicator lever
once and it activates the indicators when you operate the central locking.
5

Technical description

MagicTouch MT2000 provides two extra functions for your vehicle:
Flashing
When you press the indicator lever once, the vehicle flashes on the left or right
three to four times, depending on the flashing frequency.
Confirming the central locking
The comfort indicator module can be connected to the central locking. When it
is activated directly or by remote control, the indicators flash to confirm that the
vehicle has been locked or unlocked.
6

Installing the comfort indicator module

Note
If you do not have sufficient technical knowledge for installing and connect-
ing the components in vehicles, you should have a specialist install the de-
vice in your vehicle.
Select a suitable installation location (fig. 4, page 4).
Note
When selecting the installation location, observe the following instructions:
➤
Install the comfort indicator module
– In the vehicle interior
– Under the dashboard
– Not directly beside ventilator nozzles.
➤
Make sure the comfort indicator module and cable set are well away from
moving vehicle components such as the steering column, clutch, brake and
accelerator pedal, in order to prevent it from being crushed or worn.
➤
If you install the comfort indicator module behind panels, make sure you can fit
them again afterwards.
➤
Where possible use existing holes in the vehicle.
➤
Screw the comfort indicator module securely to the vehicle with the screws
supplied or use double-sided adhesive tape.
Take care not to damage any other parts of the vehicle when tightening the
screws.
20
MagicTouch MT2000