Installation; Maintenance Space Requirements - Komfovent DOMEKT REGO 600HE Installations- Und Bedienungsanleitungen

EN

INSTALLATION

1. Air handling unit
2. Air duct connections
3. Sound attenuator
4. Rubber mat (not included in unit set)

Maintenance space requirements

It is recommended to install the air handling unit in a separate room or in the attic on a hard smooth surface insu-
lated with a rubber mat. The place for the unit should be selected with allowance for minimum access to the unit
for maintenance and service inspection. The minimum free space in front of the control panel should be not less
than 700 mm. The free space over the top of the unit should be at least 300 mm (5 Picture).
Rubber mat must be used when unit is going to be mounted on the wall.
Ductwork
The air flows in/out air handling unit through ductwork. We recommend using galvanized steel (Zn 275 gr/m
ductwork, to ensure easy cleaning and durability. It is necessary to use the ductwork system with low air flow rate
and small pressure drop to have necessary air volume and low sound level and save the energy. The appropriate
sound attenuators will reduce the noise level of the fans in the premises.
All ductwork should be insulated with 50–100 mm thickness insulation to avoid the condensation.
Note: temperature sensor B1 has to be mounted in the supply air duct under electric heater (see the functional
diagram in Control System Electrical Installation and Operation Manual). It is necessary to leave space in straight
air duct for sensor mounting and guarantee the space for maintenance and service work. Minimal space between
the unit and B1 sensor is the space of double air duct diameter.
16
Unit Installation Scheme
2
4
Minimum Maintenance Space for Horizontal Units
UAB AMALVA we reserve the right to make changes without prior notice
2
1 3
4 Picture
5 Picture
)
2